Surface Preparation & Coating
Superior adhesion starts with a superior surface — no abrasives, no residue.
About This Service
What Is Surface Preparation & Coating?
Coating adhesion failure almost always starts at surface preparation. Contaminants, oils, old coatings, and mill scale left on a surface prevent proper bonding — leading to blistering, peeling, and premature coating failure that costs far more than the prep work.
Dry ice blasting removes existing coatings, paint, adhesives, and surface contaminants without leaving abrasive media embedded in the substrate. The cleaned surface is free of contamination and ready for immediate coating application — no blowing down, no solvent wipe.
Our surface preparation work is used in industrial, marine, aerospace, automotive, and architectural applications where coating performance is non-negotiable.
Call (636) 330-4324
Why Dry Ice
The Advantages
Safer, cleaner, and faster than any traditional industrial cleaning method.
No Embedded Media
Unlike sand or soda blasting, dry ice leaves no abrasive particles embedded in the substrate.
Superior Adhesion Surface
Cleaned surfaces are free of oils, coatings, and contamination — optimal for coating bonding.
No Blowdown Required
No abrasive residue to remove before coating. Surface is ready immediately after blasting.
Selective Removal
Remove just the failing layer while preserving primer or basecoat below. Reduce material waste.
No Hazardous Waste
No chemical strippers, no abrasive slurry to dispose of. Clean process, clean compliance.
Faster Prep Cycles
Faster than chemical stripping, cleaner than sandblasting. Reduce prep-to-coat time significantly.
Applications
What We Clean & Treat
Our surface preparation & coatingservices cover a wide range of equipment, surfaces, and environments. If you don't see your application listed, call us — we likely have experience with it.
Discuss Your Application- ✓ Industrial coating and paint removal
- ✓ Powder coat removal from aluminum and steel
- ✓ Marine vessel hull preparation
- ✓ Aerospace component cleaning
- ✓ Concrete floor coating prep
- ✓ Pipeline exterior and interior prep
- ✓ Foam and urethane removal
- ✓ Adhesive and gasket residue removal
The Process
How It Works
From first call to clean equipment — a clear, efficient process every time.
Surface Assessment
We identify coating type, substrate material, and adhesion requirements to set blasting parameters.
Containment Setup
Blast area contained to capture removed coating debris. Especially important for lead paint or hazardous coatings.
Dry Ice Blasting
Existing coatings, adhesives, and contaminants are removed from the substrate. Surface is left clean and dry.
Surface Verification
Cleanliness and profile verified. Coating can be applied immediately — no waiting, no additional prep.